Windmill Mobile Phone Charger

I Blade a) Diameter - 100mm 60mm b) No. of wings - 4 8 c) Air opposing angle of wing - 42° 45° d) Type of blade - Exhaust type, CW / CCW e) Width of the blade - 27 mm f) Material of construction - Polypropylene. II Generator a) Diameter - 34 mm b) Outside shaft length - 15 mm c) Shaft diameter - 2 mm d) No. of terminals - 2 (-,+) e) Commutator - Three segmented f) Voltage - 3.2 vDC to 12vDC g) Current - 500 mA to 1 amp h) Direction of rotation - Anti-clock wise/clockwise i) Coil - Rotating j) Magnet - Permanent & stationary III Stand/Fitment a) Material of Construction - HDPE b) Orientation - Both directions c) Adjustment - Spring tight and nut fitment IV Output a) Voltage - Regulated with IC b) Over current - Controlled with cut-off circuit c) Short circuit - Tripping circuit involved V Required RPM - 3200 rpm VI. Required wind speed - Above 20 kmph at 25°


There are 57 comments about this post (3 pages).