04/03/2006
Interactive LED Dining Table

From the article: "Each node has an amplified photodiode that senses changes in ambient light above its region of the table. An analog integrator (memory) averages that signal along with input from its neighbors, and the resulting signal is used to drive one of two strands of 14 LEDs (depending on polarity) with intensity that depends on the integrated value. Each node consists of one photodiode, one quad op-amp IC, nine resistors, and four capacitors that we hand-soldered onto a tiny piece of plain perfboard. We mounted the nodes to sheets of masonite pegboard, such that the output LEDs fit through the holes."



There are 142 comments about this post (6 pages).